Sunday, May 24, 2015

Ama Panel Prep

Since joining the panels, there has been a couple weeks of work on the table.  There are quite a few steps to be done on each hull panel interior face.  There are six panels.


  • Cleanup puzzle joints.
  • Fill screw clamp holes from puzzle bonding with a syringe of thickened epoxy.





  • Sand panels and edges.
  • Put three coats of epoxy on edges. I found it was easier to get this done before surface coating. 
  • Sheath the inside with 300gm/sqm satin weave glass.
  • Trim excess glass at edges of the panel at mid cure.
  • Hot coat a second fill coat on the glass before full cure.
  • Once cured, sand any remaining fiberglass overhang missed by trimming flush with panel edge.
  • Scrub amine blush off with 3M Scotch Brite and water. Mop amine off the surface with a sponge.  I use a small bucket of water and I change the water as soon as I see any cloudiness from the collected wax.  Dry the panel with a clean towel before it starts to dry.  You want to get any remaining amine off while it is in solution and has not dried back onto the surface.




  • Hand sand panel with an 80 grit flat board to flatten the coat and knock of high spots where epoxy might have pooled.
  • Sand panel to a dull even color eliminating all shiny spots.  This used a random orbital sander with 80-100 grit.


  • Bevel off interior corners of edges where they will be bonded together to form chines.  This allow the wired panels to sit against each other much easier than with sharp corners.  I used a laminate trimmer with a V bit.



  • Vacuum, vacuum, vacuum and wipe, wipe, wipe the panels clean.
  • Recoat the panel with epoxy, scrub and sand four more times.  I switch down to 120 grit on these coats.
  • Stack the panels in symmetrical pairs.  Measure and mark the locations of holes for wire stitching.  These are placed 1/2 inch from the edges at increments of 5 - 7 inches apart.  I want them evenly spaced so that the panels while tighten uniformly.  The hole locations need to avoid the bulkhead placement points where you won't be able to manipulate a wire.   The two panels to be stitched together must be marked at the same places along the chine.
  • Once the layout is correct.  Drill holes through both panels at the same time.  This is done with a 9/64ths bit.
  • Glue the stringers along the main hull panel shear.  There will be a separate post on this.



Task time: 95 hours
Total project time: 597 hours